N Gauge Corridor Connectors

[Barry M]

All the corridor connectors are made to type only. One size will definitely NOT fit all! I remember we even borrowed coaches so they could be designed to fit.
Barry

[kesdrive]

Mark 1 coaches are close to the class 108 DMU.

Chris

[Unclealbo]

Thanks to all for the information and advice. I will give my coaches a good looking at and make sure I get the right ones.

[Unclealbo]

Well I finally got around to playing with connectors and bought some Collets and some Mk 1's.
I fitted a Collet set to my 108 and gave it a run. The unpowered unit derailed. Because the newer 108 has a fairly large chunk of moulded bellows on both units, the gap is a bit tighter than coaches so the card bellows were quite compressed. I cut one section of the bellows off and tried again. Better but still the unpowered unit still derailed on a section with a bit of an 's' in it.
Then it struck me that I had put the bellows on the unpowered (lighter) unit and the blank on the powered car. A quick swap over and all is fine. Even with a section removed, there is no gaps at any stage and it looks superb. Thank you Barry and Mark for an excellent product. Now for the coaches.
Allan

[Newportnobby]

I'm pleased to hear that as I have a few sets I haven't tried yet

[RBTKraisee]

Well I finally got around to playing with connectors...

It would be nice to see some pictures, if you can?

Ross.

[Newportnobby]

Well I finally got around to playing with connectors...

It would be nice to see some pictures, if you can?

Ross.

@RBTKraisee Ross, have you seen the video in the OP?

[Unclealbo]

Not sure how to post a picture or video but I'll give it a go in the very near future.
Allan

[RBTKraisee]

Well I finally got around to playing with connectors...

It would be nice to see some pictures, if you can?

Ross.

@RBTKraisee Ross, have you seen the video in the OP?

Yeah, the vid looks cool. I was just curious to see Allan's set, given he had an "interesting" issue that he managed to solve

Ross.